Dear Tarek,
Thank you for your support and the helpful recommendation.
We were able to identify the root cause of the BLE instability. The issue was not due to the GATT table definition itself, but rather caused by a Zigbee stack call (specifically zclSampleSw_updateCurrentSummationDeliveredAttribute…
Hi Carlos,
Relying only on S11 measurements is not the recommended route for power matching. The identified optimum load impedance is a compromise between many factors (detailed in Section 9 of SWRA640 ( CC13xx/CC26xx Hardware Configuration and PCB Design…
Part Number: CC2652P Other Parts Discussed in Thread: SYSCONFIG Tool/software: Hi all, as in Aug1 2025 in EU the RED DA regulation will be enforced which means the EN-18031-1 list of requirements has to be meet by many products. Some of requirements are…
Part Number: CC2652P Tool/software: Hi Expert,
My customer wants to share the same layout between CC2652P and CC2674P.
I check the pin definition in datasheet. They are p2p.
I check the reference design. RX_TX connect with RF_N(pin 2) in LAUNCHXL-CC1352P…
Part Number: CC2652P Other Parts Discussed in Thread: LP-CC2651P3
Tool/software:
Hello Team,
I am working with a new application and I am using the CC2652P1FRGZR considering the 20dbm PA. So, I have a couple of questions for that:
Does the antenna type…
Part Number: CC2652P Other Parts Discussed in Thread: Z-STACK
Tool/software:
Hi Team,
Use CC2652. The issue of not being able to connect to the ZIGBEE gateway.
In register_task.c file, when reg_step is ZB_REG_STEP_ZB_CONNECT,
1. Please help analyze the reason…
Hello Senjin,
I wanted to give you an update to let you know that the Zigbee R&D Team is close to a working solution and that we will hopefully be able to provide you with a fix to this issue by the end of the week.
Regards, Ryan
Part Number: CC2652P Other Parts Discussed in Thread: CC2340R5
Tool/software:
Hi TI team, I only used one CC2652P ZC and one CC2340R5 ZED test, and the two devices sent ZCL data to each other every 50ms. After about 4 hours of testing, the ZC automatically…
Part Number: CC2652P Other Parts Discussed in Thread: CC1354P10 , Tool/software: My device has several endpoints which all have the same on/off function. Starting from the zed_lights example, I have done:
zclGeneral_RegisterCmdCallbacks( HYDRONIC_VALVULES_ENDPOINT1…
